Troubleshooting

Messages you may see, why VectorMill shows them, and what to do.

VectorMill refuses to write a program it cannot stand behind, and says why. Most entries here are refusals of that kind. They describe VectorMill for Rhino; the standalone application uses the same machining core.

A job opens but cannot be edited

The job was saved by a newer version of VectorMill than the one installed, or its record is damaged. VectorMill keeps such a job unchanged and turns editing off, so that nothing is lost or cut wrongly.

Install the newer version and open the file again. A job that uses a newer feature, such as stock to leave, is refused by earlier versions on purpose.

UCCNC: the program has no G20 or G21

That is intended. UCCNC programs do not set units, so the units of your UCCNC profile must match the file. The program’s header says which units it was written in.

Constant velocity is refused for my controller

GRBL, grblHAL, FluidNC, Masso and the ACU-RITE MILLPWR G2 take no G61 or G64. Their operations post with exact motion, and a constant-velocity setting is refused rather than silently ignored.

Post job refuses and asks for another work zero

With work zero on the stock top, each file is written for Z0 set with a height setter on the top at work zero. If earlier files leave no level top within 10 mm (0.4 in) of work zero for the height setter, VectorMill refuses the job.

Choose another work zero, for example a stock corner that stays uncut, the stock bottom or the part top.

A ramp or helix entry is refused

Ramp and helix entries and the drilling R plane must be at or above the stock top. Raise them, or use a plunge entry.

An operation is marked in the Browser after I set a tool stickout

The operation cuts deeper below the stock top than the tool sticks out of its holder. Check the tool, or the depth. VectorMill does not model the holder itself.

A new program on a 4th axis turns the wrong way

Air-cut first to see which way A turns on your machine. If it is reversed, set Reverse A in the setup’s Rotary section and post again.

Saving a reviewed program fails

Save recalculates to make sure nothing changed since the review. If the job was edited in between, review it again and then save.

Still stuck

Write to support with the details listed on the support page: Support: being set up.